Skip to content

Your Cart

Cigar head and foot shown side by side, labeled for cutting and lighting

How to cut and light a cigar evenly

Nov 19, 2026

0 comments

Javier

Cut a thin slice from the closed head, leaving the seam that holds the wrapper in place. Light the opposite end, called the foot, by rotating it near the flame until the exposed tobacco glows evenly.

Find the head, cap and shoulder

The cap is the little piece of tobacco that closes the head of a handmade cigar. On a straight-sided cigar, look for the curved shoulder where the dome meets the body. Under a strong light you can usually see a fine line running around the head. Make the first cut above that line, on the rounded part. Cutting down past the shoulder can free the outer leaf and leave it unwinding in your hand.

Most cigars have exposed filler at the foot. Some, including Warped La Colmena, have tobacco folded over the foot on purpose. Check the maker’s description if both ends look closed. The band position alone can be misleading.

Make the first cut

Remove cellophane, cedar and any ribbon at the foot. With a sharp straight cutter, place just the top of the cap between the open blades and close them in one clean motion, keeping fingers clear. A short, shallow cut gives you room to adjust. On a torpedo or pyramid, start near the tip and take another small slice only if the opening needs it. A punch suits a broad, flat head and is awkward on a pointed one.

Check the draw before lighting. If a pointed opening is obviously too small, widen it a little. Repeatedly cutting farther down a flat-headed cigar won’t fix a tight spot in the middle of the bunch.

Toast the foot and check the rim

Use an odorless butane lighter or a long match after its initial flare subsides. Hold the foot near the flame and rotate the cigar so the rim warms evenly. Keep the flame far enough away that it doesn’t run up the outer leaf. Once the surface is evenly toasted, take a few gentle draws while turning the foot near the heat.

Look at the foot. If one patch is still dark, give that patch a brief touch of heat and check again. Reheating the already glowing side can start an uneven burn. If the cigar goes out later, tap away loose ash and apply the same gradual approach. See Habanos’ illustrated cutting and lighting guidance.

Related reading

About the contributor · Javier covers cigar sizes, buying questions and the day-to-day work of the iHeartCigars shop.

Leave a comment