Skip to content

Your Cart

Dunbarton’s Todos Las Días Double Wide Belicoso. Compare its short taper with the Oliva torpedo below before deciding where the cutter should sit.

How to smoke a torpedo cigar and get the draw right

Oct 23, 2026

0 comments

Javier

Look at a torpedo from the side before you put it anywhere near a cutter. The open end, where the filler is visible, is the foot. The pointed, closed end goes in your mouth. What makes the shape interesting is the stretch of taper between that point and the full width of the cigar. A shallow cut leaves a narrow opening. Moving the blades just a little farther down exposes a wider circle of tobacco, which gives you some control over the draw before you ever strike a match.

Follow the slope of the head

On a straight-sided cigar you can usually see a fairly distinct shoulder where the rounded cap meets the body. A torpedo gives you a longer slope to work with, and the maker may have finished it with a very fine point or a relatively blunt one. That's why a fixed instruction to remove a quarter inch can go wrong. Lay two different torpedoes next to each other and the same distance from the tip can give you two quite different openings.

Dunbarton’s Todos Las Días Double Wide Belicoso
Dunbarton’s Todos Las Días Double Wide Belicoso. Compare its short taper with the Oliva torpedo below before deciding where the cutter should sit.

A sharp double-blade straight cutter makes the first attempt easy to judge. With the blades open, pass just the end of the point through and look from the side to see how much tobacco sits beyond them. Keep the cut square to the length of the cigar and close the blades cleanly. You want an actual opening through the cap with plenty of taper left to hold between your lips. A tiny clipping that only takes the paper-thin tip off may leave the end practically sealed.

Let the unlit draw tell you how far to go

Take a gentle draw before lighting. Some resistance is comfortable, much like sipping through a straw. If you have to pull hard enough to hollow your cheeks, look at the end you just opened. When there's barely a pinhole, a second thin slice is a sensible adjustment. Look at the new opening before you try again. There's no reward for squeezing several cuts into one movement, and the bit you take off lands in the ashtray for good.

Once there's a generous opening, put the cutter down. Resistance can also come from a tight spot in the bunch farther along the barrel. Repeatedly shaving the head in that situation leaves you with a stubby mouthpiece and the same tight draw. Keep your fingers off the taper when testing it. Pinching the end or biting down while you draw can close the very passage you're trying to judge, especially once the tobacco has softened.

What changes once it's lit

Oliva Serie V Melanio Torpedo
The Melanio Torpedo narrows toward the capped end. The opening gets wider as a straight cut moves down that taper. Oliva Serie V Melanio Torpedo

Light the open foot as you normally would, then let the cigar settle into an easy pace. A modest opening delivers smoke through a narrower space against the palate. Some people enjoy that sensation and describe it as concentrated. It also means that drawing harder to get a bigger mouthful can heat the cigar unnecessarily. If the draw was comfortable before lighting, give it a little time before deciding that the opening needs more work.

The pointed end tends to sit in one spot between the lips, so moisture and pressure can take their toll there. If a good draw gradually becomes tight, first take the cigar out of your mouth and inspect the opening. A fold of damp tobacco pushed across it is a different problem from a clog deeper in the bunch. If a trim is warranted, rest the lit cigar securely while you get the cutter, keep the ember clear of your hand and take only the smallest clean slice you need.

A straight cut, an angle or a V

An angled straight cut exposes an oval on the taper. It can give you a larger opening while preserving more length on one side, though the thin edge is easier to catch with a tooth. A deep V can work on a broad, sturdy taper. On a sharply pointed head, lining up the blade is fiddlier and the notch can split a fragile tip. A punch needs a flat landing surface, which is in short supply on an intact point.

The Oliva Serie V Melanio Torpedo is a good shape to inspect in a shop photograph. Follow the outline inward from the full-width body and picture the small circle a blade would expose at successive points along that slope. The same exercise works on a blunter belicoso, although you'll reach a wider opening sooner. Once you see that geometry, choosing a cut becomes a matter of how you like the cigar to feel in your mouth, with enough intact cap left to keep the wrapper where the roller put it.

Related lessons

All Cigar University lessons

Leave a comment